Username:   Password:   
   
   surfing Forum
Index  FAQ  Search  Memberlist  Usergroups  Profile  Register
 Log in to check your private messages
how do you remove a tail block traction pads
  Post new topic   Reply to topic x-surfing-x.com Forum Index » General surfing Forum     
Message
Pulse     Reply with quote
how do you remove one of those half sort of tail pads that stop your foot from slipping off, it is not peeling or anything l just need to remove it for my new full traction pad.
Cheers Daniel
Cool     Reply with quote
This is difficult, & is easier on epoxy boards than fiberglass boards. If u want to remove a tail pad from a fiberglass board u run the risk of delaminating the board, pulling the fiberglass away from the foam. This could ruin ur board, so it’s not recommended.


do it very, very slowly & carefully, a little at a time. If you’re going to put a new pad on, don’t worry about a little sticky adhesive left over. If u just want to get rid of the thing completely, a small amount of paint thinner on a rag or paper towel should take care of the adhesive.

the dude in the video isnt the best one but its the only one l could find
Display posts from previous:   
  Post new topic   Reply to topic x-surfing-x.com Forum Index » Generalsurfing Forum     

Lates Messages



You can post new topics in this forum
You can reply to topics in this forum
You can edit your posts in this forum
You can delete your posts in this forum
You can vote in polls in this forum