my surfboard has a hole in the middle. it is as if you had nailed something in it. It is as deep as the halve of my finger, and almost the same width. Is it possible to repair it?

get a new one

try a fiberglass repair kit

yes it can be fixed. Just do not put it in the water with the hole there. Take it to a surf shop and they should be able to patch it up.

Best bet is to have a pro repair it. If you can not afford it get a repair kit. Mix the epoxy with some filler to lower the density of the epoxy and fill the hole almost all the way. Go over the top with some more epoxy without the filler, or better yet with a small patch of fiberglass.

you have 2 choices, both are goin to cost you about 20 bucks. either buy a repair kit and do it your self( its about 20 bucks and not very hard to do). or take it to a shop and pay someone that does it all the time about 20 bucks to do it for you. if you have taken it in the water just make sure its dry before you get it repaired or you will ruin your board. good luck.

Yah.. just stick a bid wad of gum in da hoe. Yah.. that should do the trick.

u should get a new board, this one is not that great any more